Buy HCG Injections, Lipotropic B12 Shots & More

Instructions » HCG Diet » HCG Mixing + Dosing Instructions

Mixing Instructions for HCG


PDF Icon

WARNING: IF YOU ARE, OR MAY BE PREGNANT, OR HAVE RECENTLY BEEN DIAGNOSED WITH CANCER, DO NOT USE HCG.



Mixing Instructions: (Once reconstituted, the vial must be refrigerated)

Slowly inject 5ml (Large syringe to the 5 mark) of Bacteriostatic Water into the vial of HCG (dry powder)



Sscreenshot Screenshot

It is recommended that you take the injection the same time every day to maintain the HCG level. Morning is best.


Dosage Instructions Regarding HCG:

After following Mixing Instructions (dilution), fill small insulin syringe to the 17 mark (0.17ml), two notches above the 15 or 3 below the 20. Inject once daily. Morning is the best time for HCG Injection. For best results, use HCG for 28-days on and 28-days off. This way, the body maximizes the benefits of the HCG. You can continue with a 1,200 calorie, high-protein, low carb diet for the 28-days off. Please follow all instructions carefully.




OVIDAC HCG ONLY



HOW TO MIX 5000IU’S OF HCG FOR 200IU DAILY INJECTION Take out the following supplies and follow the instructions below:

  1. 10 ml bacteriostatic (bac) water
  2. 10ml clear vial
  3. Small vial which contains the HCG (inside of OVIDAC box)
  4. 3ml mixing syringe
  5. Alcohol pads

IMPORTANT NOTE BEFORE YOU BEGIN: Inside of the manufacturer's package that contains the small vial of HCG, you will also see a clear ampule, which is labeled as “Sodium Chloride.” Please discard the sodium chloride ampule, as it is NOT used in the mixing process for the HCG diet.

Step 1 – Make sure you are working on a sterile surface, and do not touch your needle back to any surface after you start, to keep it sterile.

Step 2 – Locate the bacteriostatic water (10 ml vial with the orange or blue top) and the HCG (you will see powder or what looks like a small white tablet on the bottom of the very small HCG vial which has a purple top) which is contained within the white and green box that says OVIDAC. 

Step 3 – Clean the tops of the sterile vial (empty sterile vial has a shiny blue or silver metal lid with a rubber stopper in the center) the bacteriostatic water, and the HCG vial with an alcohol wipe.

Step 4 –Insert your 3ml mixing needle into the bacteriostatic water and draw out 1 ml.  (It works best if you put the bottle upside down, with the needle underneath the bottle and pull the water out).

Step 5 – Inject the 1ml of bac water into the small vial of HCG slowly. You must remove the purple top off of the HCG vial for this step.

Step 6 – Swirl the HCG vial gently [DO NOT SHAKE] to completely reconstitute the HCG. Shaking the HCG vial could damage the solution. This also avoids adding too many air bubbles.

Step 7 – Draw out the 1ml of liquid from the HCG vial back into your mixing syringe.  Hold the HCG vial upside down and needle underneath the HCG, with just barely the tip of the needle into the bottle, so that you can get out all of the HCG.

Step 8 – Inject the 1ml of liquid HCG, now in your mixing syringe, directly into your empty, sterile mixing vial. (shiny blue top)

Step 9 – Draw out 3ml of bacteriostatic water 3 more times and add to your sterile mixing vial for a total of 9ml of Bac water added to the original 1ml of HCG in the mixing vial (use the method mentioned above by holding the bacteriostatic water vial upside down and your needle underneath, when drawing.) – Gently swirl to mix. Do not shake.

Step 10 – You now have 10ml of HCG which, after mixing, must be kept refrigerated. Store in a safe area of the fridge where the cold temperature will be most consistent and try to avoid direct light.